adminandClaude Opus 5.5
32cb5b4ba5
A sprite or collider could only be sized, turned and scaled through
the inspector. The scene view now draws a size gizmo on the selection,
so the common edits happen where the object is.
- Edges and corners set Width and Height. The opposite side stays
where it was, so the position moves by half the change. Sizes land
on whole units, at least 1.
- A circle collider has edge handles only and stays round. A polygon
or frame collider keeps its own corner editing and gets no size
handles.
- One knob on a stem above the top edge turns or scales. The first
5 px of the drag decide which: out from the centre scales, sideways
turns. The choice holds until the release, so one drag never does
both. Turning and scaling share one handle by the user's choice.
- Shift snaps a turn to 15 degrees. The turn adds up the swept angle,
so it goes on past a half circle instead of jumping back.
- The values are overrides of this placement, like "Fit to sprite".
A value equal to the asset's own clears the override. One drag is
one undo step.
- A handle reaches 7 px outwards but only half that into the object.
Otherwise a press near the edge of a small sprite sizes it instead
of moving it.
- The rules live in src/editor/sizeGizmo.ts without Pixi. The handles
are drawn and driven by src/editor/viewport/sizeGizmoEditor.ts. The
test hook __gm.sizeGizmo() reports them in screen pixels.
Found on the way:
- The first e2e run failed the play-mode drag check in 41b. It grabs
the 40 px crate 6 px inside its bottom edge, and the full grip zone
took that as a resize. The half zone inside fixes it.
- A first gizmo check failed because the sprite's right edge lay
outside the scene view (x 940, view ends at 925). The test was
wrong, the sprite now sits further left.
Tests:
- ./check.sh: 156 files, 2283 tests, CHECK EXIT 0 (before 2273).
- 10 unit tests in tests/editor/size-gizmo.test.ts.
- 6 new e2e checks in 29j: handles present, edge resize with the
opposite edge fixed, undo, knob turn, knob scale that ignores a
later sideways pull, circle radius.
- e2e 1-16,29,39-43 on the final state: ALL PASSED, 663 checks.
- Counter-checks: deciding the knob mode on every move fails the
"does not turn it" check. Not moving the centre on an edge drag
fails both edge checks. A full grip zone inside fails the new unit
test. Originals restored.
- Check total 1357 + 6 = 1363, computed. CI measured 1357 at d257298.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>