adminandClaude Opus 5.5
c1a702bc39
Sheets such as "TD - Tileset - Plains" draw an autotile as a 6 x 4 block: a 3 x 3 nine-slice, a vertical and a horizontal strip and a single tile on the left, the inner corners on the right. The floor kind only knew the RPG Maker 2 x 3 layout, so these sheets could not be used as autotiles at all. - New TileKind "terrain" with 16 px tiles in a 6 x 4 block. All 47 neighbour combinations are resolved per quarter, so the renderer, the collision and the palette stay untouched. - Whole tiles are used where the sheet draws them: the 16 side cases, the four single notches and the two diagonal pairs. Hand-drawn strips and single blocks therefore look as drawn. - Only the missing cases are composed, for example an edge with a notch or two notches side by side. They take the side tile and put the notch quarters in. - A notch also takes the quarter above or below from its notch tile when fill would stand there. Tall cliff notches keep their wall. On ground and stones fill meets fill, so nothing changes there. - The label rule for floor and terrain now runs through one notch function. Floor still passes the MZ table test. Not touched: the tile board only refits on open and on Fit. Switching an open tile to a kind with another tile size leaves it small until Fit is pressed. That was the case before. Tests: - ./check.sh: 156 files, 2290 tests, CHECK EXIT 0 (before 2283). - e2e 39,40: ALL PASSED, 90 checks (before 86). 39j checks 47 tiles, pixels of single, notch, pair and composed tiles, and undo to floor. - Counter-checks: without whole notch and pair tiles one unit test and one e2e check fail. Without the taken quarter one of each fails. Originals restored by cmp and rebuilt. - Check sum: 1363 measured by CI plus 4 is 1367, computed only. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>